injection pressure造句
例句與造句
- Research on lpg free spray at low injection pressure
燃料噴霧過程的研究 - Adjust injection pressure and injection time
調整注塑壓力和注塑時間 - Influence of the injection pressure to plastic mould core offset
注射壓力對塑料模具型芯偏移量的影響 - Bottom - hole injection pressure
井底注水壓力 - Laborotary experiment of water injection pressure decreasing by surfactant
表面活性劑降低注水井注入壓力室內實驗研究 - It's difficult to find injection pressure in a sentence. 用injection pressure造句挺難的
- Raise injection pressure
增加注塑壓力 - Peak injection pressure
峰值噴油壓力 - Air injection pressure
空氣噴射壓力 - 1 . bouble cylinders balanced injection system 2 . multi - steps injection pressure and speed system
二多級壓力，多級速度射膠系統 - The injection pressure of e30 engine corresponding to the lowest fuel consumption is higher than that of diesel engine
E30的最低燃料消耗率對應的噴嘴啟噴壓力略高于柴油。 - Injection pressure should be set low initially and increased to the point of filling the part just short of causing flash
一開始應設定低的射出壓力以填充零件至剛好不會造成毛邊。 - Effects of injection pressure on the microstructures and mechanical properties of short glass fiber injection - moulded reinforced polypropylene
短玻纖增強聚丙烯注射壓力對微觀結構和力學性能影響 - A study of the development model for electronically controlled fuel injection system with high injection pressure for military heavy duty diesel engines
軍用大功率柴油機電控高壓噴油系統的開發方案研究 - It ' s the first time to question extensively the influences of fuel delivery advance angle and injection pressure on performance of e30 engine
首次系統地研究了供油提前角、噴嘴啟噴壓力對e30混合燃料發動機性能的影響。 - The cross - section area of the internal sprue , the fill speed , the fill time and injection pressure are important die casting technology parameters
摘要內澆道截面積、充填速度、充填時間和壓射比壓都是重要的壓鑄工藝參數。
更多例句： 下一頁